more sm465 disassembly questions

http://www.novak-adapt.com/catalog/sm465_parts.htm

in this diagram part #s 35 and 33 ( Bushing, mainshaft journal )

how do I get these off? They seemed to be pressed on, what is the best way to remove them?


Thanks
-Dante

 

I think the best way to remove them is with a sharp cold chisel of about a 1/2in width. The bushings ore made from a brittle material. A few moderate hits along the bottom of the 'scallops' on two opposing sides will do. Ive yet to ding the surface of the shaft, the bushing go 'ping' and their off. They are however destroyed in the process. Buy new ones.

 

Yep. Cold chisel, split down the the middle.

 

Sounds good.


I'm note worried about the shaft anyway. That's the part I'm replacing for the swap.

 

worked like a charm!