My 4.3 tbi has both feed and return on bottom, it seems to run well but I never let it get to low.
My drivers side header on my cj3a just rusted out. I was thinking of going over to cast iron manifolds. Can any body suggest a drivers side...
I've got a engine host but no jack my vote would be out the front.
My 66 cj5 didn't have a safety latch, fortunately no body was behind me the night I forgot the side latches. My 76 came with both . I noticed...
I had to put in a new water temp gage but Im getting to old to stand on my head to re do the under dash wiring, so out came the Sawzall. Now...
Looking at the steering box mount and tyrod end it looks like buba's been hard at work here. But compaird to what I just looked at the side of the...
I remember when i drove my 66 cj5 Fhead (all stock) in the 70s I would be happy when I managed to get 12 miles per imperial gal on the hyway at 50...
Thanks for that other tread (I still seem to be a search engine dummy) The oil I buy has the Mil-L-2105 spec on it which answered all my questions...
Does any body have 1st hand experience using GL5 lub in there trans/tcas and then doing a tear down. I know its not recommended for trans with...
I was in the same boat when I bought my 3A 5 years ago. Herm had everthing to put it back on the T case
I put mine in Battery box on the passenger side rear fender tucked under the roll bar diagonal,fasten down with a ratchet strap.
My gas cap had a vent that was painted over when I got it. I just cleaned the vent and have had no problems sense. I replace a carb engine with a...
I already have the (cheep)? replacement electric wipers that sell for around $65 on my CJ3 but look like they couldn't handle more than the...
Teflon pipe dope is a better, no bits to brake off and clog things. Still use sparingly.
I like that idea, in fact I would like to change the hole front of of the engine from the serpentine belt to v belts which would free up some...
My 4.3 came out of a 90 S10. the rad in the truck had a nipple on the right hand tank for the return hose. There is no taping in the water pump...
I also have a Griffin rad from Summet but I still haven't finished my swap. I am still trying to find a place for the heater return hose because...
After sitting that long there is a possibility of water contamination. I would change out as much as the fluid as possible.
Ive never seen ducts like that before except maybe on a early Land Rover, I am on the lookout for some kind of effective ducting for my CJ3a. Phil
To change the subject slightly are they the original defrost ducts on your Mitsubishi. Phil
Separate names with a comma.