57cj5, On my ARB covers, the supplied bolts were all 3/16" to long. Grind down the lead end of threads as necessary. I do not recommend ARB'b...
If I remember correctly, the early 283's & 350 harmonic balancer were pressed on. The 327's have a center bolt torqued @60ftlbs.
Mine has three shafts, two hangers and no slips, and works fine.
I am running the M21, nothing like the old RC22, noise wise.
I Don't know how accurate this is. Muncie 4 Speed Transmissions
Thanks All for your insight on this. The gears ran quietly, but knowing one is compromised will bug me. The best price I can find for Tera gears...
Hi Guys, I tore down my D18, changing to twin stick. The intermediate gear has one chipped tooth and the output shaft gear shows some wear. I...
So if I advance it about a tooth I think I should be at about zero as it looks like its at about 15 or20 degrees after. I'll mark the housing on...
This is his. http://i1180.photobucket.com/albums/x411/roadworker00/SANY1300.jpg
I am with Walt & Steve on pulling the engine. Freeze plugs seem to run in packs. Replace all of them.
Yes, the rotor turns half the revolutions of crankshaft, IE: 2 to1 .
[IMG] [IMG]
The trapped air will not let it fill to the top. Was there any oil in the filter housing? If any oil is present, I would recheck, gauge,...
This is a Ramsey PT1-J, bolts on rear of D18 transfer case. [IMG] [IMG]
So, how many thousands of an inch of lifter pre-load did you end up with ?
Pre-Load on lifters should more in the range of .030 ... .060.
Oiled.
This is what is messing me up. Comp's pushrods for the 225. COMP Cams 7869-12 - COMP Cams High Energy Pushrods - Overview - SummitRacing.com
Hi Patrick, I am not trying to make trouble, just trying to sort this out.
Hmmm, ??? I went out and looked in my 1972 vintage book. It shows the rockers oiled through the head, and the rocker PR socket oiled through the PR.
Separate names with a comma.