I don't know how to check if it's getting spark. I just found a post on the internet saying that the symptoms of a bad ignition module would be...
Hey guys.. well this old sbc 350 is giving me more problems :roll: It was running great, minus a little blowback. I took it to the shop at the...
Alright guys that did it :):) I sprayed some air back through the line and all is well. Well I suppose that means that I'm going to have to take...
Ok thanks guys that helped. I fed the pump gas from a can and it fired right up. So it looks like my fuel pump is working fine. When you say it...
How would I prime the pump?
Yessir the fuel filter is in line. There is no fuel getting to the filter. Does the new fuel pump need to be primed somehow? I noticed a bit of...
Hey guys. Well I got my new Qjet hooked up on the sbc 350 and the jeep was running nice idling in the driveway. I took it for a test drive and got...
Alright so I got the new Qjet hooked up today, and the ole girl is purrin like a lion. I hooked up the electric choke with no problems. Thanks...
Ok so I got an update from the shop. I guess it takes a week to figure out that they don't know how to install bearings, and lockout hubs, and...
Well I adjusted the valves and played with the tuning a little bit. I did get some improvement, the engine will run if I keep my foot on the gas....
Well I just caught the carb on fire again, so there goes that. I read on another forum that my valves might be too tight, and that would also...
Alright guys so I got the spring loaded needles in today. I waited to tear down the carburetor until today, so I would have a fresh memory of...
Ok thanks for the knowledge. Much appreciated!
What's up everybody. So I need to rebuild my T90 Tranny. I see everyone raving about the T19. I was wondering if it bolts right up to my D18...
Yes I did change the base gasket. It doesn't look exactly like a Qjet, it just has the 4 barrels with the back 2 being larger. But yeah it's...
Thanks Corveeper I'll give the rebuild a shot. I'm almost tempted to just buy a reman QJet. Have you had a lot of problems with your Carter? I'm...
Ok Thanks for posting that manual. I guess I'll run this CarterFlood until I can upgrade to a good QJet. I'm almost tempted to tow it to the shop...
The Qjet was a 1986, and it had some extra options on it for a computer. The motor is a 1969, so no need for all the extra "ports" sticking out...
Ok thanks for the advice. I ordered the off road kit, and I'll check out the float height while I'm waiting on the kit in the mail. Appreciate...
Hello. I recently switched carburetors on the 1969 sbc350 in my 1948 CJ2a. I had a quadrajet that needed work, I took it into to get it rebuilt....
Separate names with a comma.