x2
Could be the diaphram, could be the check valves. Only way to know is to open it up.
Do a little polishing on the back side where it won't show & see what happens.
How's the output of the T98 configured? IIRC the M715 used a divorced xfer case & does not adapt well/easily to an attached case.
Actually if you split the felt into two you can get one of the halves in with the two FM seals. Not sure if it actually helps anything but what...
If you go the double seal route again (much recommended) these are the ones you want- [ATTACH] How's the surface of the output yoke? if it's at...
That's where the oil pressure sensor goes, looks like someone replaced the idiot light with a gauge & now the hose is missing. I'm surprised that...
Other side bleeds ok? Can you get fluid at the flex hose over the pumpkin?
Any lathe is better than no lathe :D Is it home yet???
[ATTACH]
nah. [ATTACH]
Is it the little button or the big flat rubber disk?
He's just gone back to his home planet...
Better tack-weld just to make sure...:bananatool:
https://worcester.craigslist.org/pts/d/boylston-willys-jeep-pickup-truck-parts/7736447122.html
17 mm (where did THAT come from???) with a taper for the pulley.
For those prices I don't get the seeming complaints about the colour of the buckles or window sizes or velcro or that the canvas is khaki instead...
I've done it but on 10" trailer brakes, not benxix 11's. I hacked an appropriately sized/shaped hole for the cable to come in at an angle, welded...
I made my own- drilled a couple of holes right next to each other in a chunk of 1/4" scrap, cut it half with a hacksaw & tack welded the result to...
Those must be some mice :shock:
Separate names with a comma.