I need to know if there is any form of ID or VIN on the frame of my 1974 cj5. If there is where would it be located. Please help. thanks
It all started with a 1974 CJ5 with a stock 304, t-15,dana 20, dana 30 and dana 44. 33 x14.50 mickey thompson hp, 4 inch lift. Motor was bad ....
Will a 78 j10 steeing box work on my 74 cj5 ? The j10 is 304 or 360 . my cj5 is a 304! thanks for your help
ok this is a stupid question but where does this go . i ordered this thinking that something totally different. does this go in the big tube on...
Just bought 1974 cj5 304. The jeep is smoking pretty bad ( white smoke) and some oil is coming out the exhaust. does it sound like i need to...
i got my new brake hoses in the other day ( i got rubber ones ) well they have 1/8 stamped on them and this is where i have a dilema. i was going...
i have got a 2.5 " lift on the jeep with 11 inch brakes all around and was wondering if i should get the ss braded lines or the rubber ones? is it...
well i just got done putting the passenger side knuckle back togetherwith the new seals and all . i was jus wondering how hard are you suppose to...
how thick should it be ? is it worth it ? i heard and read it scratch easy? any input would be great.
and installed it? jus wondering was thinking about doing this. How easy are they to put in.
Found some for cheap and was just wonderin?
Just wondering cause bout to polish knuckles before putting on the new seals?
i've seen them for sale for 76-95 and was wondering if these will work? by the way i have a 52 m38a1. if i can't use the 76-95 hinge where can i...
i have a 52 m38a1 but i think any early cj5 sending unit will do. Also where can i get a new mechanical sending unit?
i was working on my jeep today and had pulled off the steering knuckle on my passenger side . well the axle shaft was sitting there so i was jus...
i got a superlift 2.5 inch lift and when i install the u bolts onto the spring plates they are not straight . it is because the plates are not...
I tired putting the oil seal on the back of the steering knuckle and then putting it on. No luck . so i took it off and tried to put the oil seal...
Tool & Equipment Index Metal Fabrication Benders, Lathes, & Tubing Notchers Item# 14420 Northern Industrial Tools...
jus wondering wich is better and stronger ?
Separate names with a comma.