http://www.willystech.com/wt/Model18TCase/Model18TransferCase.html It's in here somewhere....
Did they mention how the seal surface on the yoke was? If it was chewed up, it'll eat up a new seal. IIRC, both my 25 and 44 have a small hole...
This. Worked well on mine. Patience is the key, as is a light hand when it comes to trying to turn them loose.
I don't have any experience other than what I've read, but is it possible your u-joints aren't 'timed' or 'clocked' the same on both sides of the...
A D25/27 spindle is a good part to have for the swivel part. Could even run a piece of plate 90* up from the tongue and bolt the spindle onto that.
Is there a chance it's leaking from the shim pack? If that's the case, you might be able to to make a one piece shim to eliminate the stack and...
Yup. EVERY time Old Bill started sputtering it was because there was a hose or fitting that worked loose. Except that time the pump and the carb...
You've got a great Jeep and a great attitude. With a little time, you'll do just fine. FWIW, My wife told me the same thing when I got Old Bill...
Those are there by fate, not design. I'll let you know how they function once I get the chance to test them out....
Yeah, I got that reaction as well.
At least that's what my local metal place tells me when I ask for it. Well, today, I proved it to myself. Had a 30" octagon that was given...
Dang! Another project on top of the pile. One day, my wife's gonna find me buried out in the garage... :D
It's been a while, so I don't remember how much $$$ it cost me, but all you need are the backing plates to start. Everything else *should* be...
I've had two very similar situations (in other vehicles) that turned out to be a bad battery in one and a short in another that ended up being an...
Sweet! (Brain turning now....)
I crimped, soldered, gooed, and finally shrink wrapped. The 'goo' is some sort of dielectic(?) gel from Radio Shack. Keeps dirt and water out of...
When I put on the 0~1" lift Rancho springs, they easily gave me 3 to 4 inches of lift because the old springs were so worn.....
Finally got the off road hitch done, as well as the 2" ball hitch this weekend. The off road hitch in it's entirety. (Jeep not included.)...
:drool: Sweet! Gonna turn some heads in that!
OK, got the swivel part incorporating the hub worked out today.... [IMG] [IMG] Hopefully get to the other two axis' in the next week or two....
Separate names with a comma.