1973 CJ5 PTO WINCH QUESTIONS I am looking around for a PTO Winch for my 73CJ5 and have a few questions: I have a Ramsey STC-3 PTO that will bolt...
Added those pics
If I were, forwhatever reason, to run around without a hood (let alone without fenders) I would use a K&N filter and use filter grease to seal the...
Awesome. Assembled them in this folder for reference: http://s1161.photobucket.com/albums/q505/notonk/Jeep%20Seats/
Nope. I have done it. Use a K&N.
They have innersprings and I have both types of passenger brackes in stock. One with the tube and another that has the tube with the foot....
Great thanks. I am starting to think that some PO knocked out the pivot bolts normally welded-on where you can see the now, hardware bolt..
I have seen em on a 1974, but the passenger seat brackets were different and had the pivot that fit into the two-holed pivot bracket/receptacle...
It just may be off of a Tux model Walt.. The PO had 2 bolts in both of the passenger legs where I had expected a pivot point....
Check the adjuster - Clean the adjuster, then lubricate its threads with high-temp grease. Compare the new brake shoes with the old ones and...
Identifying 60/40 Front Split Bench Seat Below are images of a 60/40 seat that I acquired with origional covering. Note that the passenger...
Manufactures took out most of the Zinc additives from oil because zinc will eventually clog up catalytic converters in the modern exhaust system....
Photos to help: http://s1161.photobucket.com/albums/q505/notonk/
Do make sure that the replacement sender float is not the junk plastic one as it's likely to fill up with gas over time...if yours has the plastic...
Yea, I did see the Georg's Jeep parts thread. Nice way to go if lacking the parts. My current linkage is good (knock on wood), I have two short...
Thanks Nick!
1972-75 CJ5 Wiper Link Identification Motor to Pivit Link: I have two of these and am trying to figure out which is correct. I found the part...
I have a set of their Renegade II vinal stickers on mine. They were not an exact fit and had to trim mine. If you do order a set, best to do it in...
Separate names with a comma.