How does the forward edge attach to the windshield? The PO had a piece of 2x4 across the inside edge? Any pics would really be appreciated.
Rebuilding the cylinders and want to know what sort of lube to use on the rubber pistons. Thanks
Hello all. Are there any issues to deal with when installing the OD with out dropping the Trans/TC? Not in the mood to drop it all if I don't need...
Does the V6 clutch use a return spring at all? If so, is it internal or external? Can't find any info.......thanks
Found threads that mention it, but where can I find one?
Hello all. Here's the situation. I realize that the rear driveshaft doesn't have much slip travel when the vehicle is unloaded, maybe only about...
Hey all, I finally have everything I need to install the whole assembly. What I'm having trouble figuring at is which hole in the firewall does...
Hello all, have a 66, with the dauntless V6. Looking for some help with part numbers or resources for the fuel pump ....the one with the extra...
Has anyone come across a good fitting cover for the early jeeps. I'd like to keep the jeep outside with the top off, and have the protection from...
Finally getting around to replacing the POS valve covers with the stock originals. I Don't have a oil filler cap though. I've checked a couple of...
I've searched the forums for spare tire mounts(lots & lots), but I've only seen pictures of the side mounted or the rear bumper setups. How about...
Did the 10" brake system come with the self adjusting mechanism? My '66 had nothing installed. Thanks
66 cj5, V6, 10" brakes... Looking to replace all the brake lines in the system due to corrosion from sitting so long. Does anyone carry a...
I'm in the process of rebuilding my oil pump...and while inspecting the cover assy I noticed that the bypass valve does not seat properly. I can...
Is there anyone with pics of their gas pedal setup with something other then the original. I would think a hinged pedal on the floor like the 4...
1. Where is the stock location for it? 2. Is engine heat a factor in it's placement?...ie...can it be mounted near the block or does it have to...
Need some help with this thing.....this is my first jeep, and I am learning quite abit about compatability of parts(to say the least). The PO had...
V6 225 oddfire.... Had to replace the flywheel and now I can't find any reference as to proper installation...alignment with crankshaft....and I...
So the PO installed the clutch assembly with two pressure plate bolts broken off in the flywheel. I was able remove one, the other no luck. Aside...
Hello all, Just picked up a 66 cj-5 with the buick V-6....going over the engine, and found the bypass hose fitting on the timing cover...
Separate names with a comma.