So I've got my front hubs off the spindles at long last. As we've all seen, they're really flipping rusty, and I want to de-rust them and get them...
Anyone care to explain what's so hot about an I6 engine, and why everyone rushes to suggest them over a V6? I know that they were "special"...
Ok, so we have a thread on stands but not on jacks. The Tux-in-a-barn has a record three attempts at jumping off both a scissor jack and a bumper...
Ok, not another Pinion Yoke thread. [IMG] Can anyone tell me what the round thing is that's blocking me from getting to the spindle nut, and...
So I finally got that electric impact wrench I've been wanting for so long. 1/2" drive, 240 foot-pounds, all that. Vroomp! Then I decided to...
Ok, I'm getting close to moving to the front axle on the Tux-in-a-barn, although things are moving slower than I'd wanted because I seem to have...
So I finally got the hub off the passenger's side on the Tux-in-a-barn, and discovered that the hub and drum are swaged together, and I couldn't...
[IMG] So my shaft yoke ist kaput. Someone on JF told me that I can't just unbolt the yoke and replace it without rebuilding the whole diff....
So I was re-reading the part on the Spicer 18 on Novak's website, and it got me to thinking. If you have spalling on the intermediate shaft, you...
So the FSM suggests I should use a special hub puller for removing the rear hubs, and then a friend says I have to use a bearing puller to get the...
So it turns out that the impact wrench I was looking at probably won't be strong enough to bust the lugs off the Tux-in-a-barn. That means I'm...
So I want to add a fuse box to the Tux-in-a-barn, and Painless decided to hike its prices a bit more than I like. I've got a wiring diagram which...
Ok, here we go. From here on out this is likely to be a mirror of the one on Jeepforum, but this group has a different membership and might be...
So just like the title says, my '63 tux-in-a-barn has an ominous grinding when I turn the back wheels. I was pretty sure it was bearings and the...
I figured nobody else has taken the armrest snap-screws off their Tux to have a good look at them, so here's a photo of how they're supposed to...
So the Jeep-in-a-Barn is going to eventually need its axles overhauled, and I'm considering removing the driveshafts over the holiday (or at least...
So the Jeep-in-a-barn has a huge problem: its driver's side seat is a mess and the passenger's seat is completely gone. I figured someone would...
Hey there. Been a while, because I've been busy with a lot of stuff. Haven't been able to put much attention onto the old monster, but I finally...
Separate names with a comma.