The Holley developed a leaky accelerator pump ..So.... [IMG]
I guess the proper answer is what you said, my past experiences says the actual displacement of the cylinders matter more than the total...
The best part about the swap is my 2A still has all the Jeep character, 4 cylinder engine,easy steering and marginal brakes :D Well,it stops if...
The weather is ok the last few days so I've been driving on the road some.The Chevy 153 is smoother on the road than the Willys engine even though...
The flat area over the piston,commonly caused "quench",is very important.It provides mixture turbulence to make a faster burn, make a bit more...
All fixed,drives like a Cadillac :p I installed the new springs with no castor shims.I didn't check toe in .. The angle finder fits ok by holding...
The one spring is sacked out,junk.......No shims from the factory?.....Then I'll try that first.. I found the bottom kingpin cap to be reasonable...
Well,junky U bolts ain't the only problem.I pilled the front springs today figuring to disassemble them and knock off the rust and dirt.What i...
Yes,probably.The new U bolts should be here today.Then I'll check the toe.Some have suggested a castor issue,castor is supposed to be 3 degrees...
It's not a personal attack but a true statement.I didn't mean to sound like a jerk.But I have done a lot of hot rodding , swapping carbs,and have...
I don't know who wrote the article above but perhaps he needs to stop by my house and drive this 153 engine with the 225 Mopar carburetor and then...
Yeah,stock steering
i swapped in the Chevy 153 engine and probably Jeep front end probably lost 100 pounds.The front end is now about an inch higher.This Jeep is...
Not exactly based on experience with inline 6 engines.For instance,three Harley Davidson side draft carburetors that feed two 40 inch cylinders...
Took a ride today to with the new engine.Zips right along,at least compared to the 134 flattie. Carburation is a bit lean with no manifold heat...
The carb fit as is...I know it a good one and have no others and also want to get it running .The 153 uses 2-15/16 mounting pattern which is the...
This is what the lump looks right right now. Fits very nicely and looks kinda stock. [IMG] The stock gas pedal is still in place...
It's a touch more than a SBC at about 7.25 inches.The water pump center is about 5.5 inches above the stock lower radiator mounts welded to the...
We'll leave the suspect motor mounts now that the engine ,transmission and transfer case is all bolted in.I had to swap the guts in the transfer...
Don't be,we have different opinions on what's going on.Without opinions there's no discussion.
Separate names with a comma.