1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Search Results

Search Again
Page 1 of 2
  1. razorsedge
    Post

    Boxing the frame

    I just added the full roll cage with the frame tie in kit from 4 wheel hardware. My fiberglass body is safe now.
    Post by: razorsedge, Jul 20, 2005 in forum: Early CJ5 and CJ6 Tech
  2. razorsedge
    Post

    Replacement gas tank

    I have just looked for the for sale forum......email me at jeeppaul@bellsouth.net......
    Post by: razorsedge, Jun 24, 2005 in forum: Intermediate CJ-5/6/7/8
  3. razorsedge
    Post

    Replacement gas tank

    I have the skid plate too
    Post by: razorsedge, Jun 21, 2005 in forum: Intermediate CJ-5/6/7/8
  4. razorsedge
    Post

    Replacement gas tank

    I have a 76 fuel tank that was in my 74 that I just replaced last night with a fuel cell......It has a leak around the vent tube but can be...
    Post by: razorsedge, Jun 21, 2005 in forum: Intermediate CJ-5/6/7/8
  5. razorsedge
    Post

    flat tow and locking hub questions

    I used 3 degree shims to bring the pinion down and my jeep drives and tows much better
    Post by: razorsedge, May 31, 2005 in forum: Early CJ5 and CJ6 Tech
  6. razorsedge
    Post

    Installed new (rebuilt) tranny... WOW

    what year jeep did you put that t-176 in?
    Post by: razorsedge, May 14, 2005 in forum: Intermediate CJ-5/6/7/8
  7. razorsedge
    Post

    Power Steering

    also I already had the pump, brackets, and steering box. I came up about 2 and a half inches on the hose.
    Post by: razorsedge, May 9, 2005 in forum: Intermediate CJ-5/6/7/8
  8. razorsedge
    Post

    Power Steering

    went to hydraulic shop today. Due to the difference in the size of the fittings they could not do it. I found a race shop and bought parts to...
    Post by: razorsedge, May 9, 2005 in forum: Intermediate CJ-5/6/7/8
  9. razorsedge
    Thread

    Power Steering

    I have a 74 CJ5. I am adding power steering. Can someone tell me which pressure hose to buy. The one that I have is too short.
    Thread by: razorsedge, May 9, 2005, 3 replies, in forum: Intermediate CJ-5/6/7/8
  10. razorsedge
    Post

    New top - windshield angle?

    I installed new supertop this past January. I haven't been using my door upper halves because they don't fit. I have 4wd hardware fiberglass tub...
    Post by: razorsedge, May 9, 2005 in forum: Intermediate CJ-5/6/7/8
  11. razorsedge
    Post

    This is why i stopped working on my Jeep

    better make sure about the balancing....I installed a V8 in my jeep and was having the engine balancing done and took my I6 flywheel and the guy...
    Post by: razorsedge, May 5, 2005 in forum: Early CJ5 and CJ6 Tech
  12. razorsedge
    Post

    Rim Offset?

    I run 33X13.50's on 10 inch X 2.5 backspaced rims and they do not rub anywhere.....I have flexed it very hard and bumped the back corner of the...
    Post by: razorsedge, May 2, 2005 in forum: Early CJ5 and CJ6 Tech
  13. razorsedge
    Post

    Duraspark Module Gets Hot, Quits

    I have been away for the weekend.....Anyone have any ideas....I will try the Dodge ballast resistor on the module......The coil hasn't...
    Post by: razorsedge, May 2, 2005 in forum: Intermediate CJ-5/6/7/8
  14. razorsedge
    Post

    Duraspark Module Gets Hot, Quits

    the link above does not work.....go to Google, type in amc ignition upgrade, it will take you directly to article I used to do my ignition system
    Post by: razorsedge, Apr 28, 2005 in forum: Intermediate CJ-5/6/7/8
  15. razorsedge
    Post

    Duraspark Module Gets Hot, Quits

    my mistake www.ifsa.org/tech/electrical/ignitionupgrade.shtml
    Post by: razorsedge, Apr 28, 2005 in forum: Intermediate CJ-5/6/7/8
  16. razorsedge
    Post

    Duraspark Module Gets Hot, Quits

    I just read the ignition upgrade article again. I have the duraspark module and the TFI coil. Article says both will take full 12 volt signal....
    Post by: razorsedge, Apr 28, 2005 in forum: Intermediate CJ-5/6/7/8
  17. razorsedge
    Post

    Duraspark Module Gets Hot, Quits

    The ballast resistor I installed is a homemade deal I found on the internet. It consists of 4 (specific part # I can't remember) diodes soldered...
    Post by: razorsedge, Apr 28, 2005 in forum: Intermediate CJ-5/6/7/8
  18. razorsedge
    Post

    Which Lift?

    I added 4 inch suspension, 3 inch body and 2.5 offset wheels.....no tire contact anywhere with 33x13.5's
    Post by: razorsedge, Apr 28, 2005 in forum: Early CJ5 and CJ6 Tech
  19. razorsedge
    Post

    Duraspark Module Gets Hot, Quits

    I installed the new module and will try it again this weekend.....thank you for your help.....
    Post by: razorsedge, Apr 28, 2005 in forum: Intermediate CJ-5/6/7/8
  20. razorsedge
    Post

    Duraspark Module Gets Hot, Quits

    Sorry if I have confused you. The ignition module is heating up so much it melts the backing off of it. Once it cools off I can drive it out,...
    Post by: razorsedge, Apr 27, 2005 in forum: Intermediate CJ-5/6/7/8
Showing results 1 to 20 of 27 Next >
Search Again
Page 1 of 2
New Posts