If I put a meyers half cab on my cj6, how much space would be left from the back of the cab to the tail gate? i.e. 36 inches 40 inches??? can...
Actually my goal would be to use the late model windshield frame with a Scrambler half cab top. then I believe later model cj5 doors would work...
will a 82 cj5 or cj7 windshield frame fit on my 73 cj6?
Will a dash from a 80-86 CJ-7 fit directly (bolt on) to a 74' CJ-6?? are they the same Height /Width?
Ok, its time to put her in the air. I'm thinking of going SRS with stock YJ springs. But have a couple of Q's... 1. Will this clear 33's...
What year postal columns are the best??? are they just a tube like the original....that bolt to the dash via a strap??
Took the alternator to autozone and had them check it. It passed the test.. so I found a wiring diagram on another thread how to wire the ammeter,...
Its a mechanical guage that has a little straw that stick out from the firewall into the engine compartment about 12" not enough to get to the...
My oil pressure guage doesn't work....I can't find where the tube is supposed to be attached to the motor. i have a swapped in 231 v6 any ideas??
no idea when the motor monts were changed.
well I just spent 4 months welding up holes on my 49' never welded before so any hole was almost impossible for me to weld without a 1/4" think...
OK, took the starter down to autozone had them check it works fine. checked all the wire with a continuity probe all fine, checked the starter...
Put a new remanufactured starter in the jeep the other day and have started and driven it fine for a day or two for a total of about 25mi. Started...
I have a offset flanged 71' dana 44 rear axle for sale in Vegas if you want to pick it up. has 4.88 gears.....I didn't know anyone makes a full...
I bought a 49' CJ3A about a year ago and would be interested in finding out where the vehicle was originally sold to. ie State/Town ect. also if...
go with the bds!! you'll get the best ride. 33x9s will fit with about a 1 1/2" lift though. with the right wheels back spacing. same thing with...
3 wires to the turn signal and 7 i think from it.
OK, my parking lights / turns signals don't work, not the fuse not the ground. i have constant power to the relay and from both other wires...
My question still hasn't been addressed. Does this system required a 4bbl manifold or can you use a mounting plate adaptor.
I have a 79'-ish vintage 231v6 motor with the stock 2bbl carb. Holley makes a 2bbl tbi projection kit that jegs sells for about $800 foot note...
Separate names with a comma.