I agree-definately valve seals. I wouldn't worry till it becomes excessive or constant. A little on start-up is fine. Just as a side note, alot of...
I bought the Denmans from the local tire place. I am not sure where the guy got them from. I know it took it a while to get them though. He got...
I am not trying to rock the boat on the NDT tire size issue here but I have a set of 9.00 x 16 NDTs in the garage that I was going to run on my 93...
Does anybody know how many thousandths I can safely take of a 304 when decking the block? Also does anybody know how thick head gaskets are? I was...
So my oil pump went out in my 304 and I have spun a crankshaft bearing--just my usual luck. Anybody have any suggestions on where to get a good...
Have you tried a pilot bushing puller? I am assuming that what is left of your bushing is just kind of seized to your crank? If you haven't used a...
I just bought a reman 2100 motorcraft for my 75 cj-5 with a 304. I put it on and the jeep cranks and runs but the carb obviously needs adjustment....
I just rewired mine about 3 wks ago. Its pretty simple, here's a link to the website I used:...
I had a Warn xd 9000 on my last wrangler and replaced the cable. I just went to the local hardware store and bought 125' of 5/16" galvanized...
Its been a while (about 5 years) but I remember seeing one in the Leon Rosser catalog and I think it was mfg by Kayline. I would also suspect that...
Thanks for the input fellas. I think I am just going to use the cut-off wheel and cut the windshield frame because I had to replace it anyway. On...
All answers stated by other members were good. I might suggest removing the shift tower on the top of the tranny so you can get better access to...
I recently purchased a '75 cj-5 with a 304. It had not run in 2 years so I replaced the carb, spark plugs, plug wires, rotor, distributor cap, and...
Separate names with a comma.