It does look like the body is shifted to far back somehow. Look at the spatial relationship of the fenders and tires. The rear axle does not look...
Hope all is well with you and yours. Were you still thinking about putting a plow on your CJ? I am going to take the electrical and hydraulics off...
I have one from my '63 CJ5. The plow hydraulic lift is electric and is still on the '63. The plow is off as is the push frame. About 8" got cut...
Thank you for the input. I will try to remove the "pill". My CJ5 does not have lock out hubs.
Does anyone have pictures or a source to walk me through performing this procedure. I am not familiar with the inner workings of any transmissions...
Is there any way to make 2wd low a possibility with stock parts. I can only be in low range in four wheel drive.
The starter on my '63 grinds and does not catch. It just makes a horrific sounding whir/grinding noise, like the starter bendix is grinding the...
It did not come with doors.
I have a '63 CJ5 I recently aquired an aluminum hard top that I was hoping to put on it. The front of the top is approx. 1.5 to 2 inches short...
I really need to find a roll bar (cage) for the '63. Does anyone know where to find one? Or can anyone give me the schematics for one?:?
The fuel line from the tank to the engine bay on the '63 appears to be copper. The line is crimped badly just below the fuel tank. Can I replace...
I installed 1.5" billet spacers on and I can turn from steering lock to steering lock without any rub on the springs or fenders. It also cut down...
I have antifreeze leaking down on my drivers side fire wall onto the floor board. I have heard that Bars Leak is bad to use in newer vehicles, but...
I'll work on it. I have been working alot and my wife helps get the pictures posted. I'll get some available as soon as I can.
Wil 1" spacers fix my spring rub issue? What have the guy's with the same set used to alleviate their issues.
My question is mainly for Blevisay, but I desperately need insight from anyone who has the answers. Blevisay advised that he had 2.5 inch springs...
I have yet to grind off the old paint to know what I have. I is a 1/4 ton trailer of some sort that has a track width that matches my '63. I was...
Is there any tricks that I will need to know when I put the new master cylinder on the '63. I have never worked on such a mechanism.
The starter on the '63 engages fine then screeches and free spins. I have to push the Jeep ahead againe with it in gear to spin the fly wheel and...
Would the tie rod flip kit from goferit offroad be a viable option or is there a reason it would not work.
Separate names with a comma.