Cool, they know me at O'Reilleys here in Missoula too. Thanks Again.
I'm looking to replace the starter on my 67 cj5 with a 225 v-6. Napa told me all they could get was a rebuild kit for the existing one. To be...
Hello again, haven't heard from you in awhile. I finally got my jeep running just right. Turns out the timing chain was loose and slipping. Got...
Thanks for the comment. The picture is taken in Darkhorse, Montana, an abandoned mining town. Yours looks like its in good shape. Good luck...
Well I'm pretty sure that the yoke off a ZJ will work, but honestly I didn't get a yoke from a ZJ anyways. I called a drive line shop in Missoula...
I had a lot of the same problems with mine and after fiddling with timing and the carb it ran ok. Then I put the pertronix ignitor system in with...
I just looked at my ZJ Yoke and discovered it's the same as my CJ yoke. I had a new drive line made for my ZJ when I had it lifted, hence the...
All right everything is for the rear end and is from a rear end. The old yoke from a 75 dana 44 axle is 26 spline count and I don't have the zj...
Will a pinion yoke from a 96 zj work with a 75 dana 44 rear end? I'm trying to make a driveline for my CJ5 (has a 75 cj5 dana 44 now and the jeep...
Might wanna check hermtheoverdriveguy.com for your power steering conversion. He'll tell you its stronger than the saginaw and it cheaper as far...
Make sure the accelerator pump is assembled correctly. I've put one together incorrectly and had the same problem you are having. I think I...
Thanks will be buying one today
[IMG][IMG]
Well I've finished putting in the Herm Based PS system with the 225 engine in a relatively stock CJ 5. Everything did end up fitting and working...
Want to upgrade my ignition system but am also wanting to go fuel injection one day, so I'm trying to decide which distributor to go with....
I'll see what I can do, so far getting the bolt on bracket and gear box into place is gonna be tight. Will probably update later.
I may have just found one online a junk yard off a 84 cutlass, they say it's off of a 231, so it should work? Thanks anyway
Does anyone know where to get rear dump exhaust manifolds for the driver side of a 231 (225 really), As I am doing a power steering swap on my 67...
Finnally worked out the pressure problem. I had to get another MC which was set up for disc in front and drums in rear. I believe it came from...
I'm gonna try a new MC today, we'll see what happens.
Separate names with a comma.