I went with hanging pedals out of a 95 Isuzu and plumbed the stock brake system into the master cylinder. The brake booster is a very small...
I run 5.38's and 33's. I love it on the trail, but i'm only comfortable doing 55mph-ish for long periods of time since that's about 3000rpm I...
For a CJ, I would think a MicroSquirt would be ideal. Mount it in the engine bay since it's weatherproof. No worries about mud/water, etc....
I did this for my Dana 27 for well under $100. No more bumpsteer too!...
I gotcha, no back seat, store stuff under the tire. I like the idea, keeps rear departure angle in check. Whatever you do, post some build pics so...
My 33" has to live on the back as well. I built the mount so I could also store a pair of metal 5 gallon cans behind it for added range. [IMG]...
If you're going to play with jetting, don't do it blindly. Get a wideband display or keep a close eye on your plugs.
I've got the factory Eaton G80 locking diff in both my 1 ton GMC Savanna van, and my 1/2 ton 4wd Silverado. Driving around in the snow is no big...
I would trust they would look more "normal" once the weight of the Jeep is on it. I have BD springs on mine, never checked without a load to see...
From what I've seen, the air doesn't actually flow through the oil like the above diagram shows. The air takes a tight turn like it shows just...
Put a new float in it while you're at it, and keep the old one in the glove box. I had mine get a pinhole leak in the middle of a Moab trip last...
The 2G I found was originally from a 1961 C10 pickup. It works great on my 231 even fire. I have preheat from the exhaust with a thermostat...
Would be awesome to see a write up on this. I'm looking to do a loc right this spring.
Cut the shafts down with a cutoff wheel in an angle grinder. Works perfectly. Tubing cutter won't work right on a threaded piece, hacksaw will...
I've got some on mine. I'm sure they were the cheapest ones the PO could find. They ran really slow when it was cold until they warmed up. I took...
I bought one for another car at my local Autozone for about $30 a couple years back. Worked great, no complaints. Looks exactly like the kit...
The aftermarket speedo I bought for my CJ a few years back is a piece of crap. Speedo is useless as the needle is all over the place, fuel gauge...
Megasquirt is a great option if you are willing to learn EFI and do a lot of work yourself. I MS'd my VW bug and I love all the capability of it....
Nearest I have been able to find the carburetor came off a 1961 Chevy C10 with the 283. I can't remember if it was a 2.8 or the 4.3 for sure,...
That helps a TON. So the it went down below the frame then? Hmmm. I think i'd end up flattening it with the stuff I do. Bummer, i'll have to...
Separate names with a comma.