Thanks. I'll post up some pics but they are definitely neked.. lol. In the process of cleaning/painting them now. I was hoping the hardware kit...
Hello, I just received backing plates from a wagon/pickup to get ready to upgrade to 11" brakes. If I follow this guide- am I good to go as far...
What does a top like that usually run? Some searches showed from 200-300. That accurate?
I have searched and searched.. found a few pictures but also read that some backing plates can be drilled if a hole is missing. 57 CJ5 would like...
Another quick question. I was looking at the differential and the bearing caps. The cap on the axle long side seemed dry. So I pulled the bolts...
I put in the smittybuilt low back seats and like them (57 cj5). Driver side went on the frame that was there with no issues, the passenger side...
Ya, i'll try to rent one from the auto store tomorrow. As for the fittings- yep, I do have those and they seem to be in working order.
Too funny. Thanks for the vent info. I went and checked mine and it was clogged full of gunk. Can't wait to see what the axle looks like when I...
Ok. I would imagine that even some new cheap springs would probably still be better than those old things. Thanks!
Ok- more progress. After multiple trips to try to find/rent a the correct hub puller- I simply used a gear puller. I know I was advised against...
But you also need to understand, if I had gotten some type of response saying "ya those look bad" or "Geesh,are you riding around with your wife...
Ok, thanks. The shackle angle is close to vertical. I'll clean them up and stick them back under there.
Hi all, Making way on my rear-end (that doesn't sound good). I have my springs out and was going to clean them up, etc. Before starting, how...
Ok- It's making more sense. Thanks for links and advice. I'll give it a shot and take pics along the way for other visual people like myself. :-)
Ha, ya- my first picture even shows it. geesh. So is it just the big axle nuts at the end and it'll slide right out? (I removed them but they...
Ya, it's the rear axle and has a big 44 stamped on the short axle side. I think it's original.
Some additional searching and i found the below.. I guess i need to find something to hit it harder with- should just slide out? [IMG]
Here's a pic of the little thing. It's the rear by the way- sorry about that. The video i reviewed showed that pin needed to be removed in order...
Hi All, Trying to replace the axle seals and have it mostly apart. I found that the little screw that holds the big pin within the spider gears...
When i replaced my tank and line- I wasnt getting gas to fill the bulb. After some frustration, finally removed the line at the fuel pump and...
Separate names with a comma.