I have never had to shim a rear axle. I have used a shim spacer on a transfer case for a TJ to help with rear driveline angles.
Please stick with steel shims, not aluminum or cast. You will thank all of us for it.
I dont remember standard specs but most of us have had good luck with a slight lift going to 5-6 degrees caster. For the life of me I cant if it...
Just spent 30 minutes looking for the ad. Pretty sure ad was pulled.
Seller says it is used, gc. $100 on marketplace. Not mine and don't know them.
We used 7018 rod to help with wear surfaces at the batch plant. Some locals use UHMW "plastic" for wear plates on small plow blades like atv's...
Iirc, I used the bolt that holds the rear most seat belt retractor in as a tie down point. Think I changed the bolt out and used an eye bolt or...
I carry a one burner stove that uses those green propane bottles. Will heat 2 liters of water in 2 minutes or so. Great addition to a rig for a...
Glad to see it coming together. That motor, trans, and other loose parts sat for nearly 40 years. I see you are using the custom motor...
Separate names with a comma.