I was tired of seeing oil, so replaced the cyl head , Intake Manifold (twice) and Exhaust Manifold gaskets. I also swapped in a new rotor and cap...
I can't find any wiper blades from 11-13" that fit my 71 CJ5's arms. The arms have a flat tang with a single cylindrical protrusion to clip the...
Did the swap a few years back but haven't been super impressed with the braking. Did some bedding in, measured temperatures and the outside of my...
Vehicle: 71 CJ5, Buick 225 V6, HEI Rant Section: I'm sick and tired of chasing my tail on this darn machine. Seems like I get everything running...
71 Jeep CJ5, freshly rebuilt Buick 225 V6, HEI ignition, Hedman headers Location: 7400 ft Just rebuilt the engine & carb (rejetted to .048",...
Found out my last block had a crack in cylinder #6 [http://www.earlycj5.com/forums/showthread.php?t=86284], replaced the block, put everything...
We're a bit flabber gasted at the problem right now, looking for some additional troubleshooting angles. On my 71 CJ5 with <4k miles on a...
Howdy, After the detonation of my bellhousing, I'm attempting to piece together the clutch system. The clutch fork lost a tang and the pivot...
Let me clarify, I SCREWED the pooch on this one. I was front wheel tow dollying my baby without the driveshaft disconnected. Vibrations happened...
I've got a 71 CJ5 [for sale in the classifieds] with a Dana 27 front axle with the hubs & disc brakes off a 78 CJ5 narrow track Dana 30. I'm...
Answer: 7/16-14 x 1", grade 8 Thanks to everyone for helping out! I was giving the Jeep a once over and found the 2 driver's side engine bolts...
Howdy y'all, Just completed a disc swap on my 71 CJ5 using a 78 CJs front D30 brake components. I plan on keeping the spindle & hub as...
I've seen 1 post where someone mentioned buying the pins from John Deere, drilling out the center pin, & then pressing the new ones in. Does...
Got the OD assembled, just can't get the nut off the back of the transfer case's main shaft. The transfer case was rebuilt 2-3 years ago, looks...
Got a 71 CJ5 w/ the Buick 225 V6. The hose going from the air cleaner to the PCV valve is ripped and I can't find a replacement anywhere. No luck...
*ANSWER* Read post #7 Got the Jeep running again thanks to some members of the forum. Took it for a test drive yesterday, and oh boy did that not...
During inspection, the bulbs were loose in their sockets on my 71 CJ5 w/ a V6... so the mechanic tried to alter the wiring to make everything...
Howdy y'all, Havn't been able to get my 71 Jeep CJ5 w/ a 225 V6 started for the last few weeks. Looks like the coil is the culprit. It's...
Still haven't been able to find any dimensions for the shift lever for a rear shift OD. It's going into a 71 CJ5 w/ a Buick 225. I can probably...
I'm almost ready to install an overdrive in my 71 CJ5 w/ a 225. I noticed a gunky sealant was used over the gasket material. Is this just RTV or...
Separate names with a comma.