I have a 1967 cj5 with a Ross steering box. Can someone point me in the right direction for a rebuild kit for this? or should I upgrade with...
I have already ordered a suspension master bushing set from rock auto. This was before I found out I needed to replace that spring. Thanks for...
After talking with a couple of my mechanic friends and browsing here, I will probably go ahead and replace all 4, I will just have to save up the...
I'm not sure what you are asking? I'm not expecting to gain anything by replacing the spring, just to make the jeep driveable is all Its a 1967 btw
My jeep was used to pull tram loads of people around a local historical park. So I assume the rear was increased to a 9 leaf pack for the extra...
The fronts are only 5 leaf packs
I am having to replace the passenger rear leaf spring on the cj5. It's cracked. The leaf spring that is there is a 9 leaf pack. My plan is to...
Yes, the Ross steering box has the plug removed and replaced with a grease fitting. I know (from reading here and other sites) that this is a no...
Can someone tell me why my whole steering column is full of grease? Is it supposed to be that way between the sleeve and the actual steer shaft?
Where do you find the black part for the air filter the connects to the top of the carb? Is there a specific part number or place to find those?
At some point someone filled this steering box with grease, I assume possibly because of that horn wire thing coming out. I will try the JB...
I can snap a picture tomorrow and post it, if that would help.
It's possible, it's a circle disc thing with a tube sticking out of it... has a hole in the end... my jeep didn't have a horn when I bought it so...
1967 cj5... I have the Ross steering box on my jeep. Bought the Tightsteer thinget from walcks4wd, seemed to take a lot of play out of the...
I figured while I'm in there, I'll go ahead and replace all the lines, fittings, rubber hoses, and wheel cylinders, with the rust that's in the MC...
The cheapest I've found is like 110 from amazon.. if other years will work and area little cheaper than that, I certainly wouldn't mind doing a...
Here is a picture of what the rear brake switch is attached to. Is there someone that could send a picture of the front brake switch so I can see...
Thank you for that link. That's exactly what I need. I'm not sure I understand why you need two brake light switches... I know that may seem...
Yes that is the one I am talking about, I know walcks has a replacement for 115. I think im just going to replace, it doesn't have a lot of rust...
Also while I'm on the topic, I am going to replace my brake light switch at the same time while I already have to system open, I have seen a lot...
Separate names with a comma.