Sold, sold,sold. I bought this new old stock clutch and pressure plate for my 63 CJ5 but the holes were not right in the flywheel. I know somebody...
SOLD, SOLD I have a complete heater from a 1963 CJ5 Tux Park. It has the blower, coils, ductwork, switches, cables. The ductwork leaves a little...
Some of you have you have followed my rebuild thread of my 1963 CJ5 Tux Park III which I finished last January of 2022. The Jeep only had 28000...
I’m very close to starting up my jeep as I close in on the finish line for the restoration. I have the rigid line running from the gas tank where...
It’s me again. I’ve installed the speedo cable and parking break cable which went well, but I’m trying to find out where they are attached to the...
I have a thread going on the rebuild section and am getting close to the end but have run in to some problems with the wiring. It’s a 1963 CJ5...
[img] [img] My fuel pump has the two fittings for vacuum line fittings and I see a metal line coming from a tee that I think is a vacuum line. I...
[IMG] I’m at the stage of installing the steering connecting rod and understand how the parts fit ( I have the shop manual) but I’m having a hard...
I am about to put the tub back on the frame and want to know what I need to install on the Jeep frame before doing this so I don’t have to work on...
I’m looking for a 30 or 31 inch tire that will fit my stock 15 inch wheels. Looking for a radial mud tire type tread. The wheels will be black in...
Here is the Jeep after I got it back to Louisiana from Colorado. It had a little over 28,000 miles when I got it. I drove it for about a year then...
When I removed my Ross steering box from my 63 CJ5 (4 cyl) there was a shim between the steering box and frame. The reason I am asking is just...
I have the brakes installed on the front axel and am now looking for the right hoses to finish the job. The original flex house are not the right...
I removed my oil pan to clean the inside of it and I removed the oil pump pick up with the float when I did this so I could clean it also. When I...
Where can you get the gaskets for the Warn WL-2 locking hubs ? I’ve looked at a few places on the web, even Warn, and can’t locate them. I think...
I’m going to install the 2.5 inch lift this weekend. I’ve been looking at the U bolts that hold the springs on the axel and noticed they are a...
I'm getting close to having my frame finished and will be starting on the reassembly in the next few weeks. I'm still trying to decide about the...
Someone has some 11 inch drums for sale from their jeep and I'm wondering if they can be used on my Dana 44 with the tapered axels. I have a 63...
I’m looking at the BDS leaf spring kit which includes shocks and has approximately 2.5 inches of lift for my 63 CJ5. I’m just researching for now,...
Greetings from South Louisiana. I’ve had my Jeep for a few years now and drove it a good bit, but finally took the plunge and started the...
Separate names with a comma.