I messaged another member here about this, but they sold their project before figuring it out. So I was reading through searches this morning...
Ive been in the precess of making quite a bit of changes to the 69 cj I have. rebuild M21 trans, swapped front axle, new power steering gear box,...
I didn't know where to put this, so I put it here because it fits the years. I belong to another forum and a guy on there has a all original 73...
Hey guys, I need your help with something. Will 76 cj5 seat brackets fit into a 75 with the tool box removed. im trying to help a lady finish her...
this is on a 69 with no harness, jeep has been hard wired. I am having a problem with my volts gauge. Its a aftermarket gauge, the problem im...
Probably silly questions, but just want to make sure. Im swaping out my 27 front axle for a 25, do they share the same size spring u-bolts?. my...
M.O.R.E Offroad sells these offset axle relocation plates that allow you to move your axle forward or back 3/4 or an 1". I tried to post a pic of...
Will a dana 41 and early 19 spline 44 rear axle bearing retainer interchange? Trying to pull the hub off of a 41 and think the shaft came out...
Long story short, I got a 41 rear and 25 front to replace my d44 and 27 front because I stripped the pinion gear on the rear and the front ring...
I have the trans and T-case out of the jeep, while pulling it out I ripped the trans mount in half, or it was already ripped.. My question is,...
Im looking for some tips on removing the warn overdrive from the 18 t/c. I took out the 5 long bolts and used two screw drivers to pry the OD...
Hi guys, gotta question for you.. The jeep was running great, so I took it for a long highway drive. It did fine until I was almost to my exit...
Well guys, im not a happy camper today. Not sure if this is posted in the right place or not, sorry if it isn't. We had a ice storm lastnight and...
Installed a cam, lifters, pushrods, timing chain on my sbc a week or so ago, The jeep was running fine. I took my daughter for a ride lastnight...
hey guys, Ive posted in the past about my engine. its a 65 327/275 hp engine, long story short, the cam lobes are wiped. So my question is what...
My jeep has a chevy 327 in it. I rebuilt the carb which is a holley 4150 650 double pumper (I know! an off-road nightmare). It wouldnt stay...
Ok, I wasnt going to post this, but I figured I might as well get some opinions. for those that don't know, I have a 65 chevy 327 in my jeep. It...
Im getting ready to put in a new set of point and condenser in the jeep. has a chevy v8 with the GM 1-piece type points and condenser in it now....
Ive got a 69-5 with 35" tires and a v8 and warn OD, 4.88 gears. In low range it is the lowest geared jeep I have ever driven. I am used to...
can someone tell me if my upper door hinges are on backwards? I dont think so, but when I open the door it rubs up against the w/s frame and has...
Separate names with a comma.