Amazon has some new masters that will arrive tomorrow and have free returns. I'll see if an early 70s CJ master will suit and return if it...
The disk swap was already done by the PO but with a single reservoir master and no proportioning valve. Go figure. I bought the bracket and master...
He says his is a special master that he has made overseas :confused: and that my pushrod is probably misaligned. If it's the master I'll probably...
I emailed him so we'll see if he at least comes up with some helpful info
I've got discs in front and drums in back.
Does anyone know what Herm is using for a dual reservoir brake master? I bought one as part of a kit probably close to the beginning of covid. I...
It was the coil. That and a carb clean and she runs like a top.
Thanks guys. Everything's a mystery until you deal with it the first time lol. I found a pretty good video on YouTube that got me through a bunch...
My 55 CJ5 has been offline for a while while I sorted out driveline and suspension issues. Those have been sorted out and now I'm looking to drive...
Yep, makes sense. Thanks!
Yes, the front has 7 leafs and the stack is 1-3/4". The front overall length of the front springs seems closer to 40.5". The rear has 6, but the...
I was just going to live with the springs that I have but I noticed that one of them is cracked at the top spring. It wasn't going to take much...
So yeah, it ends up that it was fine. After shimming the ends it took up the space in the middle and everything seems good. In the end I can at...
If I do take the differential out should I expect to be able to use the same shims, or at least the same cumulative thickness of shims and put it...
...or maybe it is. I can look down through the tubes and see that there is a spacer in there with a dark spot in the direct center of it, so I...
This can't be right; [MEDIA]
Thanks, I'm not interchanging any parts. The same parts that came out for a new seal and bearing are the ones that went back in. I haven't done...
I'm looking at the procedure now, thanks. Is it normal to shim .100 per side?
Sorry, I probably wasn't clear. The axles in this have 10 splines, the same axles that came out went back in with new bearings. The old, full axle...
I bought a rear Dana 44 to replace the original in my 55 CJ 5 which was destroyed by rust internally.The only difference with the new axle is that...
Separate names with a comma.