I will be using the flywheel and bellhousing from my old 232
Hey guys, I’ve got a 1980 258 that I will be installing in my 73 CJ5 that has a T14 transmission. I know the input shafts on the transmissions...
Any luck getting pictures? I can’t view the one that you posted
258 with upgraded cam shaft and Holley sniper EFI. Rebuilt T-14 and Dana 20. 4.27 front and rear axles.
Anybody running these tires? I’m thinking about running a set once I get my 1973 rebuilt but looking for pictures and lift specs Love the...
I believe once I get the transfer case installed onto it, it will go away. It looks like the play is coming from where the drive gear shaft slides...
I have the transmission reassembled. Ended up have to use 8 spacer washers to get the outer washers flush. I have one more question for you. If I...
Thank you for your help. I will post an update once I get it cleaned up and start rebuilding.
I can’t get a picture that shows much. Once I get the outer washers to sit flush, and install the thrust washers the shaft should be installed...
That is probably what I will do. I am going to post a picture of the case could you confirm that everything looks normal. This is my first time...
Correct. Those 4 washers. I didn’t think about comparing the length of the bearings. I just compared an old to a new and they appear to be the...
So I have disassembled my T-14 tranny. When removing the roller bearings and spacer washers from the counter shaft, I removed 4 set of spacer...
Update - got the rear bearing adapter out this morning with a very thin long punch and light taps between the teeth of the gear that is up against it.
Hey guys, I’m in the process of tearing apart my T-14. I bought a Novak rebuild kit and the instructions don’t give much detail about removing...
It seems to run well. I can hear some gear noise when I’m cruising at lower speeds around the neighborhood. Not sure if it is anything of concern...
I am planning on opening my T-14 transmission up soon to do a refresh while I have the motor out. I want to run a Novak master rebuild kit but it...
Thanks for the advice!
Is it necessary to replace rocker arms when putting in this upgraded cam? I ordered the kit from Lunati that included their suggested springs but...
Correct about the cam specs. They I’m not sure the specs on the springs. Not much info on their website for the kit as far as spring specs. I will...
I spoke with lunati the other day and he pointed me in the right direction. He did say I shouldn’t use stock springs and needed to run their...
Separate names with a comma.