What types of accelerator pedal setups are you guys running in your intermediates? Do any of you run a Lokar or similar universal setup? Pictures...
Finally took the time to pull my steering column to see what's the matter with my horn button and wiring. I've got a replacement button and wire...
Do you put RTV on the threads of this cap bolt? [IMG]
I mounted my rear Smittybilt seat using factory slide mounts and building an aluminum sub frame. I flipped the front aftermarket mounts over and...
I'm looking for the part that screws into the oil pump cover that the filter screws to. Mine has some boogered threads where it looks like someone...
I know that if I'm going to add a filter with a return, the return port has to be at the 12 o'clock position. But, if the 12 o'clock position is...
I'm about to install a new timing cover, gaskets, HRC oil pump, etc from Bulltear when it arrives. Any tips? Does Autozone have the right harmonic...
I used my day off today on a rainy day to head down to the local custom exhaust shop and get rid of my glass packs. Those were run as true duals...
Anyone know the best way to get the alternator adjusted to get proper tension on the belt to keep the belt from squealing. I've worked with mine...
Ok, so I've been having some fuel supply issues, but I'm sorting through them. One major issue that I've found with my carb flooding is that fuel...
Do any of you have a good picture of a return line setup on an amc v8? Is it 1/4"? Is it rubber all the way from filter to tank? My 73 did not...
Since my refurb is "done", I've been cruising and tweaking my jeep. Luckily today, I pulled into a gas station to fill my tank up right when Ole...
I recently cleaned up and rebuilt my T15. It shifts like it should. The only issue I have is a oil seep at the countershaft bore in the front of...
I have no horn at this time. I can't find the end of the wire coming from the horn switch at the bottom of the steering column, so I pulled the...
I just finished installing an MSD 6 ignition box for my 304. It fired right up, but my alternator warning light stayed on, and my voltmeter was...
About 10,000 miles ago, I changed the factory brake pads on my wife's 09 that we got 80,000 miles out of. I didn't change rotors or have them...
I have purchased and installed the second carb on this page: http://www.nationalcarburetors.com/performance/holley7.aspx It is not a stock Truck...
I found these angle brackets in a drawer. I believe they are to mount garage door track, and they are rigid and galvanized. I had been wanting...
Does the defrost duct screw in through the top of the cowl (I guess you call it), which is under the windshield? I have a new duct, but I want to...
I've got a new fresh air box and drain hose from MTS. Is it possible to get the old out and new one in without dropping the heater plenum? I've...
Separate names with a comma.