1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Rear axle pre-load shims

Discussion in 'Early CJ5 and CJ6 Tech' started by windyhill, Feb 20, 2010.

  1. Feb 20, 2010
    windyhill

    windyhill Sponsor

    PA
    Joined:
    Nov 4, 2006
    Messages:
    1,502
    Do I add a little permetex form-a-seal between each one or just install them dry? Nothing was on them and I'm worried about throwing the pre-load off but it seams like a good place to let moister in. maybe the grease seals them enough?
     
    Last edited: Feb 20, 2010
    windyhill, Feb 20, 2010
    #1
  2. Feb 20, 2010
    nickmil

    nickmil In mothballs.

    Happy Valley, OR
    Joined:
    Sep 23, 2002
    Messages:
    12,529
    I always put a super thin coat of sealer on them 'cause I don't like oil/grease leaks onto my brakes.
     
    nickmil, Feb 20, 2010
    #2
  3. Feb 20, 2010
    Patrick

    Patrick Super Moderator Staff Member

    Los Alamos, NM
    Joined:
    Sep 22, 2002
    Messages:
    8,360
    Yep. I use RTV (Ultra Black). Don't worry about the thickness upsetting your preload. It'll squeeze out all but what's left to fill any small voids.
     
    Patrick, Feb 20, 2010
    #3
  4. Feb 21, 2010
    jhuey

    jhuey Michigan Jeeper!

    Indian River...
    Joined:
    Apr 9, 2004
    Messages:
    415
    I use Loctite 518. Very low build when trying to maintain a bearing pre-load.
     
    jhuey, Feb 21, 2010
    #4
  5. Feb 21, 2010
    windyhill

    windyhill Sponsor

    PA
    Joined:
    Nov 4, 2006
    Messages:
    1,502
    Thanks guys!
     
    windyhill, Feb 21, 2010
    #5
New Posts