[ATTACH] [ATTACH] So I am new to the flatfender world, been tinkering with my intermediate for years. The short version of a long story is that my...
So what I am hearing is transmission rebuild next?
Well a little over a year later I have finally pulled the transfer case and replaced it with a freshly rebuilt one. Unfortunately the noise...
if you look at the first picture you can see the radius on the door that is leaning on the top. I think the extra flap of steel must allow room...
Thanks, that is a big relief... any idea why when I tighten the yoke nut I can no longer turn the shaft?
Is there supposed to be a spacer between the yoke and the bearing? I have one between the bearing and gear. The spacer in question is the same...
I did something wrong somewhere... Once I put the yoke back on and began to tighten the nut the front output shaft sized up. I backed the nut off...
Got the poppet balls figured out, now looking at my parts left I have four washers... and two trust washers three of the washers are identical and...
That is what I assumed and did. Any advise on getting the poppet balls back in?
Do you put it between each shim? Or shim to case? Or shim to cover?
Should I put sealant between the shims and rear cover?
That was supposed to be shaft bearings, auto correct on my phone... I am talking about the bearings on either side of the front output shaft.
The factory cap won't fit the HEI style 8mm wires. But your local auto zone sells spiral would 8mm wires that will fit your cap (and in four...
Well I started the rebuild of my Dana 20 today with the Novak site for direction. It went well until I got to the point of removing the shift...
Separate names with a comma.
