wheelie's Recent Activity

wheelie liked ITLKSEZ's post in the thread Let's Nerd Out On Some Calculations.

Another important aspect that was sorta mentioned in parallel with rpm is torque curve. My little European 4 cyl won’t pull very hard...

wheelie liked Howard Eisenhauer's post in the thread Should I Buy An Oil Temp Gauge?.

[ATTACH]

wheelie replied to the thread Logan 922 Lathe.

Looks nice JW. Thanks for the lead on the Logan parts. The one I looked at doesn't come with nearly as many extras as I thought. Has...

wheelie liked FinoCJ's post in the thread Logan 922 Lathe.

Skip the lathe ...finish the B....:rofl:

wheelie liked Rich M.'s post in the thread What's A D300 Worth?.

Texas pattern fetches a premium. Make sure you get the output gear for the transmission or it's worthless. I don't know about...

wheelie replied to the thread Hoist The Jib.

Yea. But all you see is getting replaced soooooo........

wheelie liked Rozcoking23's post in the thread Hoist The Jib.

Heck, that’s just a case of beer from being done, it’s already a roller.

wheelie replied to the thread Hoist The Jib.

The 3B Jules? Here it is. No progress to report. IMG_2024-04-18-065322 by wheelie posted Apr 18, 2024 at 6:57 AM And I have to finish...

wheelie replied to the thread Logan 922 Lathe.

Oh I dunno. I have 2 junk drill presses that make me angry every single time I use either one. Going to look at it after work tonight.

wheelie posted a new thread.

Logan 922 Lathe

Got a shot at an old Logan lathe. Probably from the 1940s. Flat belt drive with 220v motor. He says it’s a 11 inch swing and 36 inch...

Forum: The Tool Shed