Been toying with the idea of using an electric fan. assume it would be safer...
Brian, Yep, thats the clip. It's almost like the clip doesn "expand outward" enough. I can easily "spin it" with a screwdriver. Its seated...
Per the URL listed by Linckeil, * Remove the five bolts that run through the case of the over drive with a 9/16" socket. * Pry the over...
Reinstalled the Warn OD last night on my T90 transmission. After tightening the OD assembly (1/2 drive extension is used to do this), there's a...
FINALLY going to be installing the powertrain tonight (its only been a year)! I've got the new clutch fork and will be bolting everything back...
$33.91 shipped.....ordered....THANKS!!!
thanks for the measurements Gump! I'll check this again the one I have (with the broken spring clip). Not sure if this is an item I can pick up...
Doesn't matter....was reexaming it tonight, slid in the throwout bearing and the spring clip that holds it in place broke! I get to buy a new...
I really shouldn't be admiting this, but I know mine inside and out. During the rebuild I took mine apart/back together several times. Be sure...
Gump, thanks for taking the length measurement.. I did remove the throw out bearing then was able to get the input shaft of the trans to...
BTW, I'm using my original t90. The donor engine and bell housing came as an assembly, but now I can't remember which trans it had (jon has...
FINALLY got the engine mounts welded in (only took a year) so I'm motivated again... However,, when trying to get the trans to mate w/the...
Separate names with a comma.