I’ve got a pretty nice set of brown ones if you’re interested. Sent you a message. Joe
Thanks guys. There was no gasket on the worm gear end cap. Just a thin layer of gasket sealer and it was torqued down too tight and binding on the...
I’m new to pto winches. I just picked up a Koenig king 100. The seller said it had new seals and thrust bearings. My question is how hard should...
Nice find! I cant tell from the pictures but are you using the original hitch? Joe
Turns out it was a bad ignition box/module on the inner fender. The acc wire was back feeding inside the box to the start wire. Replaced the box...
I probably can since I finally found a picture of the switch with the terminals labeled. However, the old switch (which was working last year)...
The switch still has the factory plugs so the wires couldn't have gotten crossed there and there is only one start wire with a boot on it to go to...
I've been helping a friend get his 84 CJ7 put back together. Tried starting it today and the starter engages with the key in the "on" position...
The transmission was new in 2012 and probably has less than 1000 miles on it so I'd be surprised if the syncro hub is worn out - unless it is...
I borrowed a trailer and got it home last night. I pulled the shifter back off and the problem was staring me in the face. One of the dogs in...
I'll probably just put the old one back on since it's obviously not the problem. The cane is thinner than the new one - the fat cane doesn't look...
Well, I pulled the top cover in the parking lot and it was full of oil (almost anyway - less than 1/4" down from the fill plug). I replaced the...
There was but honestly I haven't checked it since last fall - don't drive it much. I plan to check that before I move it any further.
Separate names with a comma.
