if the stud has a concave end on it you can use an air hammer and suitable bit to remove and install them.
Since we all know that too many parts for our Jeeps are unobtainable. I've got a new windshield frame from a 1971, but with no wiper linkage...go...
great job.
i know that this topic has been beaten to death in most aspects. i'm trying to sell a full set of 10 leaf pack front and rear springs that were...
#2.
glass or steel? body lift or not?
i did the d27 disk and d44 11" conversions. i figured with the chevy 350 conversion i might need it and that i was going to use power steering...
Re: V6 Cutting out at cruising speeds? ****Oops. I missed the part of the "new poly tank"...my bad.****
on my fiberglass tub, the front 4 are 3" and the rear 2 are 2". i had to lift the body to fit the th350 in. if you're looking for a cheap, but...
thanks for the info.
I'm in the middle of installing a chevy 350 in my CJ5 and have a bit of an issue with the tie-rod to spring clearance. I've considered shims, but...
if you wanted to rivet it in place you would need an air compressor, an air hammer, a bucking bar and a rivet set. depending on the...
Separate names with a comma.