been there, done that, paid for it Check out my site. I started with an 63 CJ and added a 350 chevy crate motor with an SM465 and 18 transfer...
I run 33" tires with Dana 27's and Dana 44's in the rear. The new 350 had a field day with the drive shaft. It is true, the right foot took over...
I spun my T90 first run with the fresh 350 in front of it. Converted to a SM465 with Advance adapter kit. Here is a picture of the difference in...
Why would you want to keep the under the seat tank? It is smaller and it's like sitting on a bomb. The PO had the under the seat tank held in...
finally got some pics for ya.....
Got a little out of hand in the front yard with the power train. Lit up the 33's and played drive shaft twister. Just got the drive shaft...
I used rubber gasket under tank to prevent wear from rubbing. Bought from local hardware store for a couple of bucks. Door weather stripping is...
I did the same thing as Mike did with my 63. I used the tank from a 72 (I believe) and used the same hoses but adapted the tank to come out of...
You could always cut it out of stainless checkplating..:) Dana
Just wondering why you went with the 4:88 gearing. With that 18 transfer case and the SM465 you are going to be screaming down the freeway unless...
OK, I took a 63CJ stock and put in the following: 350SBC, Twin 18 transfer case, SM465, Electric fuel pump, 600 edelbrock, aluminum intake,...
The PO either used the wrong sized bolts (too long) or they have backed out. From what I can see, the gear wear looks good and the gears are not...
I used a 3/4" plate with 5/8" bolts holidng it down. The winch is mounted to this as well as thru bolted. I also used 3/4" bolts holding the...
Re: Fenderwell painting I hate to say it, but we were so worried about having enough paint to spray the body that we elected to not paint the...
Separate names with a comma.
