1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Recent Content by teh xerexes

  1. teh xerexes
    Post

    no pedal pressure, unless i pump it up?

    I too am having the exact same problem as the OP. I recently installed a dana 30 from a 79 CJ5 with a disc brake set up. I suppose I might have...
    Post by: teh xerexes, Apr 22, 2009 in forum: Intermediate CJ-5/6/7/8
  2. teh xerexes
    Post

    Commando dana 30 question

    Thanks. I found it hard to believe disc brakes were main stream on anything produced by Jeep in that time period. I did however see the...
    Post by: teh xerexes, Feb 23, 2009 in forum: Intermediate CJ-5/6/7/8
  3. teh xerexes
    Thread

    Commando dana 30 question

    Found a dana 30 front axle out of a '73 commando. It was $60 bucks with the disc brakes already on it but missing a caliper so I figured why not....
    Thread by: teh xerexes, Feb 23, 2009, 2 replies, in forum: Intermediate CJ-5/6/7/8
  4. teh xerexes
    Post

    Carrier Question

    Problem is, most people who take their jeeps to a mechanic(like I was doing at the time) probably haven't found this website as a resource yet. I...
    Post by: teh xerexes, Feb 14, 2009 in forum: Intermediate CJ-5/6/7/8
  5. teh xerexes
    Post

    Carrier Question

    Hm you are correct. I told the mechanic at the time to just match 4.11 gears in the rear but he went on about how I wouldn't like it "that low"...
    Post by: teh xerexes, Feb 12, 2009 in forum: Intermediate CJ-5/6/7/8
  6. teh xerexes
    Thread

    Carrier Question

    Awhile back, I had the gears replaced in my front dana 30(long story short, the PO had 4.11 gears - don't ask - in the front and 3.54 gears in the...
    Thread by: teh xerexes, Feb 12, 2009, 10 replies, in forum: Intermediate CJ-5/6/7/8
  7. teh xerexes
    Post

    Where'd my lift go?

    I appreciate all the input but I have to say that's pretty lame that the PO had those springs put on and didn't raise cane over it. I honestly...
    Post by: teh xerexes, Feb 4, 2009 in forum: Intermediate CJ-5/6/7/8
  8. teh xerexes
    Post

    Where'd my lift go?

    That's funny because looking at the springs leafs thickness and arc I didn't think it looked any where near what 4" lift springs look like. I'm...
    Post by: teh xerexes, Feb 4, 2009 in forum: Intermediate CJ-5/6/7/8
  9. teh xerexes
    Post

    Where'd my lift go?

    Ah okay I gotcha now. Is there a another(stock?) measurement I can compare this to?
    Post by: teh xerexes, Feb 4, 2009 in forum: Intermediate CJ-5/6/7/8
  10. teh xerexes
    Post

    Where'd my lift go?

    Ouch that must've been one rusty tub! Can't say there's much more on mine than some surface rust. Timgr-I don't quite follow. What exactly is...
    Post by: teh xerexes, Feb 3, 2009 in forum: Intermediate CJ-5/6/7/8
  11. teh xerexes
    Thread

    Where'd my lift go?

    I'm hoping someone can help me figure out where the hell my 4" of lift went! I've attached some photos as it looks right now on 33" tires. The...
    Thread by: teh xerexes, Feb 3, 2009, 13 replies, in forum: Intermediate CJ-5/6/7/8
  12. teh xerexes
    Post

    Jeep barely gets hot

    Not to hijack, but I ironically have the opposite problem(sorta). My temp gauge needle slowly progresses all the way to the other side and reads...
    Post by: teh xerexes, Jan 25, 2009 in forum: Intermediate CJ-5/6/7/8
New Posts