Rear crossmember time. Measured 3 times, the frame is still square, and the cut is at the rear of the tub. The new crossmember will be outside of...
Roughly twice the size and weight of a 420.
This was custom cut for a CJ. I think it's 56"-ish. And a V6 isn't going to break 35 spline axles, which puts Rob firmly in the "no worries" camp....
$3250, plus D300 say $2500, (and for that I would go Atlas), plus new rear end, $5000, if I do it on a budget. But who's counting?
Nice looking, but what is it? Do I get a granny gear? Are you saying I could move out of the '40's with my drivetrain choices?
Oh I know, and I was eyballing this one. But when it came time to do it, I hadn't ordered it, so I decided to try the old cordless, and it really...
It has crossed my mind, but the issue is I have this really nice offset high 60.
Thanks for the comments, I will talk to Tom Woods when I order the rear shaft. But look at this, I will have a 25"-ish rear shaft. Unprecedented...
I am actually trying to move forward on the project, but it is Rubicon Month, so I'm a little slow on the progress. And this makes me happy: my...
Jay, I came in late to this discussion , but I have a T86 if you want to go that way.
What I would do, and I was just doing this, is jack up a front and a rear corner to figure out the minimum and maximum length needed. Then go to a...
Now, where was I? Yeah, the month of June got busy, with work, yard work, and a little Rubicon trip. But today, I finally have a day off, and I...
Separate names with a comma.