For those who have been using fuel lines made of a nickel copper alloy, has anyone noticed notice any corrosion? My steel lines are corroding...
The more I think about it, the more I believe that I did not wire a resistor bypass into the Jeep. I don't know for certain because the Jeep is...
Thanks for the replies! I forgot about the ballast resistor bypass. The jeep is not here so I can't go out and look at it. How is the bypass...
Hi everyone. It has been quite some time since I was last on this board. In the past, the people on this site gave me invaluable information. I...
Eric, I see that you used the jack I was talking about. I take it that the jack did not give you any trouble?
Thanks for the advice. I am looking for a transmission jack now. Would I be crazy to use the jeep's winch, together with a couple of pulleys...
I greatly prefer the 3 wire set up over the one wire. I had a 10 SI wired as a 1-wire. I use the winch a lot with the engine idling. After...
Thanks for the replies. How much harder than a 70’s Chevy Pick Up is it to swap out a clutch on an old jeep? I agree, I would not think...
I am not a mechanic. Only experience with clutches was 30 years ago helping my father change out clutches in a couple of Chevy PU’s. We dropped...
I like CO64CJ5's logic. I am going to add a fuse to the output wire.
There is a plug on the back of the head on the passenger side.
I doubt it. The problem with undersize wires is that they melt if too many amps go through them. It doesn't take too many amps to run the...
Separate names with a comma.
