Okay, sounds good I’ll start some research.
My factory fuel gauge failed a long time ago. My question is can anyone recommend an after market fuel gauge and sending unit?
I just did this over the winter, I used headman outside the frame headers and had them ceramic coated and installed the dynomax turbo mufflers...
The parts manufactured for the points distributors are not what they used to be either. I used a pertronix and never looked back.
Same here I purchased the same one and and it worked for about a year and a half or about 800 miles. Where the throttle brackets mounts to work...
Sorry for the slow reply I’ve been very busy. Right now I have a replacement aluminum radiator installed 1 year ago closest size I could find to...
Is love to get the proper shroud but they are hard to find. I suppose I could set it up as a pusher and keep the mechanical fan. I believe I do...
Anyone else out there running an electric fan set up with the larger radiator on the v6? I was thinking about getting rid of the mechanical fan...
Is that Saginaw conversion done with leaving the factory front dump drivers side exhaust manifold?
I’m not trying to hijack your thread, I have been looking at these exact headers for my Saginaw swap. Are you able to connect the muffler directly...
Tomorrow I’m going to try and pull the fill plug in the 18 drain out the excess, leave the plug out and fill the t14 until it comes out the top...
That’s what’s happening here becuse I took the fill plug off of the transfer case to top it off after it sat for 2 weeks and leaked all over the...
I do remember that I think I used sta-lube last time
Separate names with a comma.