So tonight I took the whole cluster out of the Jeep. I took the cluster apart and hooked the fuel gage up independent of the cluster and I was...
Thanks for the replies, I started pulling the gage cluster out last night and should be able to finish tonight. I think that Howard is correct...
So I tried the ground from the ground on the battery and same thing. Gage act strange if I ground the S wire it only goes to the same spot and...
This is a repo gage from Kaiser Willys. Here is what they say Empty- 1/2 Tank- Full Tank- 73 ohms 23 ohms 10 ohms
Good afternoon all So I am close to finishing up my 57 CJ5 project and I have everything working except the fuel gage? I have read a lot of the...
Thanks it has and continues to be fun. Marty
All, I wanted to reach out an thank all of you for the post to me or on other issues that I needed to work on. I wanted to share a picture after I...
So just an update, I went out tonight and changed the points out and put in the Pertronix 1548 in my 60 CJ5. Took about 30 min and than I...
Thanks. I plan to change out the points tonight and add electronic ignition. With that I will have a new coil, new plugs and wires. I will post...
If it still is not running correctly Marty
All, I am attempting to get my 60 CJ5 running under load and have a few questions. Problem: it will start right up but wants to stall when you...
Here is the YouTube Thunderhead289 How to: test any engine ignition coil - simple & effective (not for current subscribers) if you just copy...
Separate names with a comma.