That would surprise me, but I will absolutely check to make sure everything is operating correctly. All wiring is new, but the switch is the...
Well the dizzy has a Pertronix pickup, and an MSD ignition box too. I had set the timing in the middle of summer with a vacuum gauge, but I’m...
Good morning, Last week was cold, and I was out trying to get the CJ5 (F134) up and running. Up until this point, she’s ran wonderfully; only...
You are correct. Well, what’s one more wire.... geesh.
I had a suspicion that the C would need to be grounded. I’ll break out the multimeter and see if it’ll ground through the case itself.
Forgive my ignorance: The oil pressure switch I ended up with has three spades, labeled NC NO and C. I know what these mean, but I have no clue...
This project has now made it to the very bottom of my to-do list...
I’m working with the F134. There’s only the one feisable location, and that’s the stock port on the passenger rear side of block. I’ll end up...
I used to run LED bulbs in the cluster, but found they were so bright, it distracted me while driving. Check out the LED options - less amperage...
This is what I’ve been finding on the interwebs as well. It appears to be the standard operating procedure for boats that have dual cockpits. When...
I totally understand! I rebuilt the cluster a few years back, and seem to remember spending several aggravating days with cheap Chinese-made...
Depends on how many sparkies you’ve got running on the dash, lights, radio, electric fan, heater, wipers, etc. I believe 10si ~60amp is going to...
Separate names with a comma.