1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

FinoCJ's Recent Activity

  1. FinoCJ replied to the thread Mounting Rack To Roll Bar.

    These are pretty cool - have a space saving flat spot for welding onto... [IMG]

    Jun 25, 2019 at 11:31 PM
  2. FinoCJ replied to the thread Mounting Rack To Roll Bar.

    thinking: The rack is 49.5 inches across, and the space across between the roll bar on each side is 50.5". The shaft collars for 2" ID...

    Jun 25, 2019 at 11:28 PM
  3. FinoCJ replied to the thread Mounting Rack To Roll Bar.

    that's the words I needed...much better time searching for stuff now...thanks!

    Jun 25, 2019 at 8:19 PM
  4. FinoCJ posted a new thread.

    Mounting Rack To Roll Bar

    Maybe this have been covered before...feel free to push me in the right direction of previous threads... Looking to mount a small rack...

    Forum: Builds and Fabricators Forum

    Jun 25, 2019 at 6:54 PM
  5. FinoCJ liked Muzikp's post in the thread Is There A Trick To Getting Pinion Out Of Dana 44.

    Yeh, forgot to mention I did that also. Although it's hard to hit it good with the drum for the emergency brake in the way. And I didn't...

    Jun 25, 2019 at 2:38 PM
  6. FinoCJ liked jpflat2a's post in the thread 72 Leaf Springs U-bolt Question.

    Maybe these charts from the Jeep parts book can help with width and dimensions for factory application. For your 72 CJ5, Use model 83/84...

    Jun 25, 2019 at 9:44 AM
  7. FinoCJ replied to the thread Willys Wagon.

    talked to the seller on the phone today...he has a tentative deal in place already, but if it falls through he will be back in touch...

    Jun 24, 2019 at 5:52 PM
  8. FinoCJ liked ITLKSEZ's post in the thread Is There A Trick To Getting Pinion Out Of Dana 44.

    You really need a 2-jaw puller. It would allow you to get a straighter pull. A 3-jaw isn’t allowing you to transfer all the tension...

    Jun 24, 2019 at 3:15 PM
  9. FinoCJ replied to the thread Is There A Trick To Getting Pinion Out Of Dana 44.

    To get the yoke off, I used a puller that threaded into the yoke as opposed to a 3-jaw. Then I put the impact socket on the puller...I...

    Jun 24, 2019 at 3:02 PM
New Posts