Rozcoking23's Recent Activity

Rozcoking23 replied to the thread 1970 Jeep Rebuild.

I just read through the build thread: http://www.earlycj5.com/xf_cj5/index.php?threads/118867/page-4 I need to figure out the correct...

Rozcoking23 replied to the thread 1970 Jeep Rebuild.

I’m hoping to be able to get this done in the JEEP, with my bad shoulder I’m kinda 1 handed and can’t do anything overhead. I just need...

Rozcoking23 liked timsresort's post in the thread 1970 Jeep Rebuild.

Not good. Not sure why the shaft would rise up and disengage enough to strip it, if the hold down was in place. I think you can drop the...

Rozcoking23 liked timsresort's post in the thread 44 Floater.

Picked up a nice little treasure. Dana 44 offset, 11"brakes, full floating axles with locking hubs. The price was right, so I dragged it...

Rozcoking23 replied to the thread 1970 Jeep Rebuild.

I have a bad feeling this is gonna cause me to pull the motor and at a minimum to clean out oil passages and replacing the oil pump...

Rozcoking23 replied to the thread Lost Oil Pressure.

The teeth on the cam gear are fine, no wear no damage. I’m thinking the distributor came unseated just enough to allow the male/female...

Rozcoking23 attached a file to the thread 1970 Jeep Rebuild.

Well I have bigger problems….was adjusting timing and I over adjusted and the motor back fired through the carb. I heard/felt grinding...

Rozcoking23 liked Stakebed's post in the thread What Did You Do To Your Jeep Today?.

The dreaded heater core and blower changeout.[ATTACH]change-up. [ATTACH] [ATTACH] [ATTACH]

Rozcoking23 replied to the thread Lost Oil Pressure.

Roll pin intact and in place.

Rozcoking23 replied to the thread Lost Oil Pressure.

I need to go back out and look at that roll pin

Rozcoking23 liked Walt Couch's post in the thread Lost Oil Pressure.

The gear on the distributor shaft is held tight in position by a roll pin.

Rozcoking23 replied to the thread Lost Oil Pressure.

I still need to pull the oil filter and pan to see how much glitter I have.

Rozcoking23 attached a file to the thread Lost Oil Pressure.

Well…. Not good! [ATTACH] look at the corners of the shaft and the shaft for the oil pump. [ATTACH] This was just with magnet on...

Rozcoking23 posted a new thread.

Lost Oil Pressure

I was in the garage playing with the Jeep, adjusting carburetor and adding a little timing to the 225 V-6. It was idling at 650-700...

Forum: Early CJ5 and CJ6 Tech