1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Dana 20 Stabilizer Stud Question

Discussion in 'Intermediate CJ-5/6/7/8' started by rixcj, Jun 22, 2008.

  1. rixcj

    rixcj Member

    Hi. I replaced all the rubber mounts on my jeep. I installed the transmission stabilizer stud the same way the old worn out one was installed. With all the nuts tight, the whole assembly is still loose. I can move it up and down, vertically. So, it doing absolutely nothing. I couldn't find any info in any of my FSM's.
    Am I supposed to add more washers until it's tight, or did I install it wrong? Any advice? Thanks.
     
    Last edited: Jun 23, 2008
    rixcj, Jun 22, 2008
    #1
  2. khamill

    khamill Member

    i believe the torque stud just prevents excess movement. the mount is what holds things solid. Some play is correct.
     
    khamill, Jun 23, 2008
    #2
  3. rixcj

    rixcj Member

    Sounds good.Thanks for clearing that up for me.
     
    rixcj, Jun 23, 2008
    #3