Okay, I hadn't thought about checking the pullys. If I want to look at my lifters, I just need to pull off the valve covers right...gimme a...
Hi everyone, I need help diagnosing a “phantom tick” in my 68-225V6 I was on a rather long road trip last week and everything was going...
If it's in that kind of condition, I say wheel it. You'll spend a small fortune trying to get it into restorable condition. Well...the...
What about the Carubretor? I had the same problem with my 225, but it was because the carburetor float was slightly out of adjustment, as well...
Hey there "hkmp5a2", I had this exact same problem in my 225. I went through the same procedures of checking the thermostat, then the...
I have a question about stopping the hot air from coming through my vents during the summer time. I did some searching on this site and I like...
Thanks for the help guys, now I have a better understanding of what's going on in there. :beer: Allan
So if I pull the plug on the bottom of the transfer case, will it drain the transmission too, or does the oil journal between the two only come...
I'm confused and need some clarification please :? I've attached a picture of my transfer case, which I believe is the model 18. I know that...
I know that all Jeeps have a habit of dripping a little oil now and then, but my t-18 is leaking heavily from the speedometer cable connection....
Yea they still have those gallon cans of "carb dip" that come with a dipping basket. At least I know that NAPA has them, can't recall the cost,...
I need help finding the correct temperature sending unit for my Jeep. I’ve got a 1968 CJ-5 with the 225 V6. When I bought the Jeep, the PO had...
The weight of my 68 CJ-5 with the V-6 was 2,480 lbs. Subtract 230 lbs for my fat *** in the drivers seat :) . I couldn't get my tabs until I...
Thanks for the ideas guys, I hadn't thought about tacking a washer to the lid, I think that's the way I might go. I know I could leave it...
I'm looking for ideas on how to lock the cap on my Jerry can. I recently installed a Jerry can rack on my rear bumper, it hasn't been a problem...
Hey Bill, The website you're looking for is: http://www.goferitoffroad.com/products.htm I did the "tie-rod flip" using the inserts...
I've never seen that before. I'd have to agree with everyone else that it's probably leftover from a padded dash or something.
gscj5, I bought the kit from 4WD Co.
Glenn, I had the horizontal bolt clamped down to the point that the bellcrank would rotate freely, as per the instruction manual. The 7/8"...
Hi everyone, I just installed my bellcrank rebuild kit and everything went great except one little problem. The new 7/8" shaft came with a...
Separate names with a comma.