1962 f134 fresh off frame build. I have 31x10.50x15 tires and a completely rebuilt Ross steering system from the knuckles up. It is very hard to...
My old pinion seal says ASD 142235. Is this a Willys part number? Came from a 3B D25. Anyone know a National equivalent ? Thanks.
what will happen if I run a front axle with mismatched ring and pinion numbers?
Went for a drive around the block and disaster struck. I was going as fast as the f-134 would go when "BOOM". The front end locked up and the...
62 cj5 f 134 new build. Went for a short drive yesterday to put a couple of miles on my Jeep and to get some gas. I went through the...
My '62 134 f-head w/ Carter carb, runs OK, a little hard to start, but hunts when cold. What is the best way to eliminate the hunting. Also,...
What does the voltage regulator in the instrument cluster look like? Do I even have one? I have a 1962 F-134. New fuel sending unit, gauge works...
My starter has a strange sound. Hopefully someone here can help me fix it. I replaced the bendix with one from Walcks but it is making the same...
I know that this has been asked probably many times but I don't see it. My generator is showing charge at the regulator but the idiot light...
1962 f-134 carter carb. I feel sure this question has never been asked, ;), but I didn't see it in my search. I'm getting close to the finish line...
Will someone please identify the terminals of the voltage regulator as found on the wiring diagram for an F 134 CJ5 1962. My regulator is...
These clips keep riding up. Is there a secret or do I have the wrong part? 1962 CJ5, F134, T-90, Dana 18. Thanks [IMG]
Can someone tell me where I can find a diagram showing tub to chasis attachment points. My search did not turn up what I was looking for. Thanks
For all you mechanics out there, what is the best way to identify the tappet that I am hearing???
I have the dual diaphragm fuel pump with the glass bowl on top. When I turn the engine off the fuel level in the glass bowl slowly drops. The...
I would appreciate some of you listening to my f-head and tell me if the tappets are too loose and if so how to tell which one(s) is the culprit....
There is almost no room between the dual MC and bell housing. What, if anything, can be moved over to make room without major surgery. F head...
After installing a dual MC and the engine I have no room for plumbing. ['62 CJ5, 134 f head, 11" drums] If I move the MC to the left the pedals...
Got a Crown Ross' box sector shaft repair kit today and have issues. The new bushings have a smaller OD (approx. .007) than the old bushings and...
I have three service manuals and can not find how large the brake lines need to be. Is 3/16 OK for a CJ5 11 inch four wheel drum conversion? Thanks.
Separate names with a comma.