I've been looking into rotating my rear axle (78 cj5) and using a CV joint to eliminate vibrations. I've read that you can take a front driveshaft...
I have a couple of questions about proportioning valves that I have been pondering. It started with an issue on a 78 CJ5 I bought last year that...
A while back I acquired a T18/d20 combo out of an early 70s CJ. It is the close ratio, however it did not come with a bell housing or the adapter...
I recently bought a rebuilt 360, not sure what year, and installed it in my Jeep. Before installing the motor, I replaced the valve covers and...
I recently bought an AMC V8 that was a fresh rebuild, and one of the selling points, was that it had an "oil bypass upgrade". After I thought...
I am installing a 304 that has been sitting for a while. I read somewhere that you can take an old distributor, install it and use a drill to spin...
Is it OK or taboo to reuse flywheel and/or clutch cover bolts? I'm swapping a motor that had a flex plate into my 78 CJ (w/manual xmission) and...
I have a T176 I am wanting to rebuild. I bought a kit that has all the necessary parts, however it did not have any instructions. I have some...
Greetings all: I recently purchaced a 78 CJ5 with a fairly new fiberglass tub. It looked like someone had done a recent partial restore. I had to...
Separate names with a comma.