it's a 285 i 6 from an 83 cj5 we'll call it motor A and i'm swaping motors with a 258 i6 from a ?? cj we'll catt it motor B. i wanted to know if...
it looks easy but every time i say that the job ends up kicking me in the head any advice out there. i'm having shifting problems now and i can't...
so my door on my tiger top still leaks but it's not because of the door the damn top just isn't long enough to properly over lap the door. so i...
this thing is very poorly designed. it seems that the top does not go past the door putting the door and the top on the same level allowing water...
[IMG] you are looking at the drive shaft connected to the front axle. it actually looks like it's going the wrong way!! the springs are kinda...
i'm looking for a lift for my 1983 cj5 that's good on and off road i don't do any serious offroading yet but i do some expressway driving. the...
all right every one i got my harness from a 79 to go into my 83 it's a little dirty but way better than the spider web that's in the rig now. got...
i found a 7500 lb 12v electric winch at sam's for $300 you can only pick it up at the sams near my house and there are about 30 of them it's got a...
here it is 12 bucks and 2 hours of sanding painting mounting balencing and beer drinking later and i got a home made console that don't look bad....
after missing all four tranny bolts!!!!! i wish i was joking but i slid under the cj to day to install my ammo can console (i'll post pics in the...
[IMG] what the heck is this? By the way i installed the ignition switch and now johnny starts up right away with no need for the coil switch,...
1983 CJ5 straight 6 Who ever wired this jeep should be hung by a rusty wiring harness. It looks like a Christmas tree. Here’s where the problem...
Separate names with a comma.