I had one that mice made a nest in. Made a horrible noise.
West Coast Customs did this with the wheel holding a whitewall ring. Similar to a bead lock without the bolts (no function either). Probably...
Same here. Steering shaft is split with a support welded to the frame. [IMG][IMG]
X2
Searched truck avenger, found this. Seems like Warloch was the resident 470 expert? http://www.earlycj5.com/forums/search.php?searchid=1213474
Sorry for the bother....:oops: Got them on, it was just a very tight fit.
I broke a 27 spline 5 bolt plastic Warn hub. Instead of changing to the 6 bolt wheel hub and premium Warn hubs right now, I opted for the Mile...
I believe you can source the right one from early 80's and older Buick RWD cars, V8 or V6. I think mine came from a 60's Skylark. Also lots of...
X2. The snow we get here is almost never dry enough(sierra cement) to use low range to go up anything. Have to have some speed and sometimes wheel...
I just bought a Haynes manual today. If you need any other info out of it let me know. Greg
Not in my case. All fluids were changed about a year and a half ago.
I think the early's typically came with 5:38's.
That was cj5/442's picture, not mine. Not sure what caused his. I have not done any fording. The jeep sat for almost 7 months until I had time...
I was wondering if it could be condensation. It had not been driven for several months while I got around to the motor swap.
Thanks for the replies. I think I'll give the motor oil a try.
Has not been exposed to weather at all.(Not sitting with trans exposed) So what did you use to clean it out? Did you reseal everything including...
Pulled the plug to check to check fluid level today and out runs a light tan goo.:mad: Guess I should have checked it while the motor was out....
If you plan on using toyota axles, you wont be able to run the D18/OD combo as it is off set
Probably need to check the casting numbers.
Bottom one looks like it came from a 231to me.
Separate names with a comma.