My dad has a 71' CJ5 with a 225 v6. While taking it apart he noticed the lobe for the fuel pump was worn and had grooves in it. Will the crank...
After cleaning and sealing my 1961 cj5 gas tank. Which is the correct threaded hole on the bottom to hook up gas line? One is level with floor...
Has anyone mounted after market seat Rugged Ridge or other brand seats in or on early CJ5 frames with the built in tubing back frame? Mine are in...
I forgot to take pictures of the heater hose route on 61’ CJ5 with a f134 when disassembling engine and removing from chassis. Does anyone have...
Has anyone had to replace the studs in a the turn signals on the front grill of an early CJ 5? Nuts froze and studs broke off of mounting plate.
I don't know what this material is called, it was used on new cj5's between the top of the radiator and the back side of grill. It was purpose...
What is everyone using as the rubber washer that goes under the nut and flat washer that holds their F-head valve cover on. Mine was falling...
What is the proper clearance of the pilot bushing in the center of the flywheel, between it and the end of the pilot shaft of the transmission?...
I need to replace the rear bumper/cross member on my 1961 CJ5. I got a new one with rivits. Has anyone just bolted the new cross member on or...
I am replacing my dash on my 1961 CJ-5 and am curious about what type of bolts people are using and how they are keeping the paint from getting...
I recently bought a new lower cluster gear for the T-90 transmission I am rebuilding. After receiving the new cluster gear I noticed that there...
I am planning on installing a rear pto and gear box for my 61' CJ5. Is it necessary to install the extra reinforcing c- channel to the rear cross...
What is the easiest way to remove a steering box? My 1961 cj5 has a 4 cylinder. I can see the 3 bolts that go through the frame and after...
How is the vent on top of the transfer case removed? Mine is covered in mud , grease, and every other thing in the world. Dont' want to ruin it...
Just completed installing a new wiring harness and fished a new horn wire through steering column. Jeep started right up , but horn did not work....
Are the wires on the bake light switch interchangeable or do thay fit on a particular terminal. This is a 1961 CJ-5 with a 134 cid. Mike Wedin...
Has anyone tried using a redi sleave on a pinion yoke. Mine has grooves worn into it allowing the pinion seal to not seal against the smooth...
What is the best way to clean out the inside of the oil bath air filter after you remove the lower pan and oil. Does the unit come a part any more?
Has anyone removed the rear main seal on the 4 cylinder while still in the jeep? Is there a trick to removing the top half of the seal , without...
When did the battery box cover disappear on the cj5's.. We had a 1964 CJ5 Tuxedo Park and it did not have one. My current 1961 Cj5 has one....
Separate names with a comma.