Good afternoon - My fuel pump is leaking it appears around the top... presumably around the gasket (notice the red arrow pointing to the gasket...
For those that may benefit....found a radiator shop as suggested. For $100 they bead blasted it to expose any other damage and remove rust,...
Got a chance to chip away at the damage this evening - it's more than a pin-hole. The largest one is 0.5 x 0.25 inch, with a few pin holes as...
Thanks to you and PeteL for the quick response - I'll give it a shot.
My '66 cj5 has the "bubble" (or funnel) described above with a nipple onto which the hose attaches, sticking through the floor. Someone smart...
also, need to remove the old belt pulley - what is the trick to keeping generator from spinning?
My brother in law at NAPA got me a Wilson replacement.... Want to make sure I reconnect the leads right: when looking from the left front fender...
I removed the belt, spun the generator by hand and metal shavings appeared... The part tag says Prestolite GJP 7402A. Can I go to my nearest...
Thanks guys. After receiving the suggestion about belt tension I tightened it up for about a half inch play and the squealing was worse which...
Good morning all. '66 CJ5 and the generator is stamped 12V by Prestone. First crank of the day, pulled out of garage and down driveway in...
Here are the symptoms for my '66 cj5 when I pulled it out for a ride this weekend: 1. Lots of resistance-free travel in the clutch pedal - I...
...and, yes, it is out of 4 WD. I drove in the grass for a bit turning the wheel side to side, stuck a needle in a voodoo doll, etc. and it...
Thanks everyone; I'll try the suggestions this weekend. Good points yall brought out: "Is your transfer case in high range when you try to shift...
I searched old topics and found some advise about hard shift out of 4WD if one was driving on pavement in 4WD due to differences in torque...
thanks for the help
Separate names with a comma.