So, I have a new/rebuilt starter from Delco, and a new wiring harness. So everything is new. Problem is when I turn the key to start the...
I'm in the process of wiring up my 70 and I have disassembled the turn signal switch with the hopes of cleaning it up and saving it. I'm guessing...
I have a new exhaust system from Waldrons. After getting it bolted up, the tie rod from the steering box to the bell crank is rubbing on it....
My oil pump cover has some scoring from the gears. Primarily on the distributor side. Less than .001" according to my fingernail gauge, probably...
But at 30 grand there has to be some gold plating that I'm not seeing? https://www.facebook.com/groups/2355912306/permalink/10159147573382307/
It's a Dauntless, from what I see in my service manual it looks to be on the wrong way.
Since I broke 2 1/2 bolts while swapping out my waterpump, I'm going to pull my timing cover and inspect/ replace the chain and gears. Since...
Am I correct in assuming that these distributors and parts for them are pretty much non existent? Just need a vacuum advance unit and have had...
I'm curious as to why my V6 only starts with two solenoids wired up? One on the firewall and the one on the starter itself. The whole wiring...
Hi all, haven't been here for a while. Life got in the way and my Jeep had to wait on the sidelines for a bit. Anyway... Is this...
I am installing the Champion "CC7071" radiator on my 69/70 V6 and am having issues with the lower hose fitting up. I bought the "continental...
Was wondering you guys opinions on different pinion setting gauges. This is the one I'm currently considering is this one from proform...
I'm changing my spring bushings. My old bushings had inner and outer steel sleeves. My new Energy Suspension bushings do not have the outer...
I'm working on changing over the brakes on a military Dana 44. The first hub came off easily with a 3 jaw puller and a whack with a hammer....
I need to replace the little springs that lock/latch my parking brake. Have been wandering around my shop and yard looking for something I can...
Round two of reassembly of my transfer case, this time without that damn interlock pin. The output shaft doesn't seem to go far enough into the...
I'm reassembling my transfer case and it's binding up. I think the problem is in the front bearing cap but I can't get it off. Seems like the...
Was wondering if anyone knows the bore and journal sizes and tolerances on a T14 mainshaft and input shaft? I haven't been able to find them...
Has dual tanks ever been an option? My 69/70 has the under seat tank and one in the back. There's a switch mounted on the floor between the...
Sitting in a junkyard right now lookung a t a 73 cj5 I'm wondering if the crossmember on this will fit my 69 cj5? Has a different transfer...
Separate names with a comma.